It will look like this: s M s M s M s M s M s M s M sĦ String the second section of week beads by repeating Step 4.Ĩ String the third section of week beads by repeating Step 4.ġ0 String the fourth section of week beads by repeating Step 4.ġ1 Take the end of the wire and thread it back through the crimp tube that was added in Step 3 (the wire will be heading back toward the cross). (Note: make sure the beads cover both of the wires-the primary wire and the “tail” that extends from the top of the cross): s L s M s L sģ String the crimp tube (this is a critical step!).Ĥ String the first section of week beads in the following pattern: s M (7 times), then 1 s. Using the pliers, squeeze the crimp tube until it is flattened.Ģ String the beads in the following pattern, taking them all the way down so that the first bead aligns with the crimp tube that sits above the cross. This will leave you with the two ends of the wire coming out of the crimp tube: the primary length of wire and a smaller “tail,” about one inch in length. Thread the end of the wire back up through the crimp tube. 018″)ġ Thread one of the crimp tubes onto the wire, then add the cross.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |